The clamping principle of GN 860 pneumatic toggle clamps is identical in construction and dimensions to the manually operated GN 810 vertical acting toggle clamps.
To ensure an extended life of the mechanical parts as well as the air cylinders, the operating pressure should not exceed 6 bar and a compressed air maintenance unit should be installed upstream.
GN 860 toggle clamps have a permanent magnet integrated into the piston. In conjunction with GN 3380 sensors, it is possible to detect the piston position, which can deliver a signal, for instance to a machine controller.
Parts in sheet metal
Case-hardened steel C10
Zinc plated, blue passivated finish
Hardened bearing pins
Case-hardened bearing rivets
Case-hardened air cylinder bearing pins
Double-action air cylinder
Max. operating pressure 6 bar
All moving parts lubricated with special grease
Spindle assembly GN 708.1, Type A
Steel, zinc plated, blue passivated finish
Rubber tip 85 shore A
Clamp mounts (for Type AP) GN 801
Clamp mounts (for Type EP) GN 809
Sensor GN 3380
Hide technical drawing
Part Options / Table
U-bar version, with two flanged washers
U-bar version, with two flanged washers and GN 708.1 spindle assembly
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.881 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 800-877-8351