In the initial position, the clamping bore axis of the swivel clamp connector joints EN 282.10 is parallel to the flange surface and can be swiveled by ±90°. It holds typical construction tubes with full surface contact over the entire cross-section of the bore.
At the screw location z1, the socket cap screw reduces the bore cross-section for clamping. Adapter bushings EN 290 can be used to reduce the bore cross-sections to smaller diameters.
The screw location z2 serves for fixing the joint axis, which can be adjusted continuously or in 10° steps, depending on the type.
For clamping without tools, the socket cap screws can be replaced by the adjustable levers GN 911.9 listed in the table as accessories.
Technopolymer (Polyamide PA)
Glass fiber reinforced
Temperature resistant up to 212 °F (100 °C)
Black, RAL 9005, matte finishSW
Gray, RAL 7040, matte finishGR
Socket cap screws DIN 912
Stainless steel AISI 304
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.238 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 800-877-8351