GN 297 bevel-gear wheels are used for angular / T-gears in connection with GN 391 linear actuators / transfer units and housings. (See GN 298 for examples of use.)
The spiral bevel facilitates both setting the desired clearance and locating the correct position of the bevel gears. Meanwhile, the spiral bevel also greatly reduces noise levels.
Two bevel-gear wheels are required for an angular gear (set sold as Type W), and three for a T-gear (set sold as Type T).
Please note that only bevel-gear wheels with opposite pitches can be paired. The transmission ratio is always 1:1 because bevel gears always have the same number of teeth.
Hide technical drawing
Part Options / Table
Bevel gear wheel, right-hand pitch
Bevel gear wheel, left-hand pitch
Set of bevel gears, 2 bevel gears, 1 x right-hand, 1 x left-hand pitch
Set of bevel gears, 3 bevel gears, 1 x right-hand, 2 x left-hand pitch
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.020 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 800-877-8351