DIN 71802 threaded ball joint linkages consist of a DIN 71805 ball socket and a DIN 71803 ball stud.
The swivel angle for the type with safety catch (types BS) is 15°, without safety catch (types B) it is 18°.
During assembly, the ball socket is pushed over the snap ring, which acts as a retainer. If the retaining force (see also pull-off force in the table above) is not sufficient, the connection of ball socket / ball stud can be secured by the safety catch, which can easily be fitted.
To protect the threaded ball joint linkages against contamination, GN 710 dust caps can be used.
The hex nut is part of the threaded ball joint linkages with threaded stud.
Specification
Housing and plain stud
Stainless steel
Property class 5
Zinc plated, colorless passivated finish
Ball
Steel
Hardened
Ball socket lubricated
RoHS
Accessory
Dust Caps GN 710
On request
Reduced resistance (ball socket with play)
Ball studs DIN 71803
Ball sockets DIN 71805
Ball joints
(ball socket and ball stud in one axis)
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.028 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 800-877-8351