The clamping bore axes of the two-way connector clamps EN 132.9 are arranged at an angle of 90° to each other. They hold typical construction tubes with full surface contact over the entire cross-section of the bore.
At the screw locations z, the socket cap screws reduce the bore cross-section for clamping. Adapter bushings EN 290 can be used to reduce the bore cross-sections to a smaller diameter.
For clamping without tools, the socket cap screws can be replaced by the adjustable levers GN 911.9 listed in the table as accessories.
Specification
Body
Plastic
Technopolymer (Polyamide PA)
Glass fiber reinforced
Temperature resistant up to 212 °F (100 °C)
Black, RAL 9005, matte finishS
Gray, RAL 7040, matte finishG
Socket cap screws DIN 912
Stainless steel AISI 304
Hex nuts DIN 985
Stainless steel AISI 304
Self-locking with polyamide ring
RoHS
Accessory
Adapter bushings EN 290
Adjustable levers GN 911.9
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.068 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 800-877-8351
ELESA original design
