GN 817.6 indexing plungers with sensor for position monitoring allow for electronic monitoring of the plunger pin state. For this purpose, a magnet is integrated into the plunger pin that switches the sensor upon engaging after approx. 2/3 of the locking distance l1.
The sensor electronics then outputs a high signal, e.g. to a machine control, and indicates this switch state with an LED on the sensor.
To prevent faults, no external magnetic fields should be acting on the indexing plunger. The GN 817.6 stainless steel indexing plungers are delivered with enclosed sensor (not installed), sensor clip, Allen® wrench and hex nut.
3-pole plug M8x1,
freely rotating with knurled screw connection, with PUR cable 0.5 m
≤ 8 mA
≤ 2.5 V
-13 °F to + 167 °F (-25 °C to +75 °C)
Shock and vibration resistance
30 g, 11 ms / 10 - 55 Hz, 1 mm
According to EN 60947-5-2
Reverse polarity protection
The position of the sensor cable can be freely determined when installing the sensor clip.
Insert the sensor into the sensor clip from the side.
Tighten the hex socket screw of the sensor.
Clip the sensor clip into the ring slot of the indexing plunger in any orientation and then adjust the direction by turning, if necessary.
Total US Dollars (net)
Call / Email for Delivery Time
Please note our quantity discounts (US Dollars).
Prop 65: -
Please contact our Sales Department for more information.
This article is RoHS-compliant in application of Annex III., which means it complies with EU Directive 2011/65/EU, including extension (2015/863/EU), for restricting the use of certain hazardous substances in electrical and electronic devices. The Directive regulates the use of hazardous substances in devices and components. The implementation in national law is summarily described with RoHS(Restriction of (the use of certain) hazardous substances)).
Weight: 0.059 lbs
If weight is not listed, please contact our Sales Department for additional information regarding weight. Phone: 800-877-8351